Instructions / Assembly

628034A 2
Attach mirror door
NOTE: For ease of door assembly the assistance of an additional
person is recommended.
1. Identify and separate the doors by type (B or C). Although the
mirror doors appear to be identical, there are two door
configurations. The doors are left or right side locations by the
striker plate on the door backs. (FIG 4) Position the door with the
striker plate at the bottom.
2. Remove the six pivot hinges from the hardware bag. There are two
hinge configurations. Separate hinges into two sets of three based
on the pin direction and screw locations. (FIG 5)
3. Slide a pivot hinge type “d” over pressure pad at the top of door
type “C”. Lightly tighten the two screws to keep the hinge in place.
(FIG 6) Repeat this process for the second door type “C”.
4. Place a pivot hinge type “c” over the pressure pad at the top of
door type “B”. Lightly tighten the screws to keep hinge in place.
5. Place the remaining pivot hinges (two of type “c” and one of type
“d”) into the holes on the bottom of the cabinet frame. (FIG 7)
Make sure the screws in the pivot hinge are clear of the mirror
channel.
6. Assemble one door at a time to the cabinet, positioning door types
“B” and “C” as shown in (FIG 8). Lift the mirror door and insert the
pin of the top hinge into the hole in the top of the cabinet frame.
Slide bottom of mirror door into the channel of the lower hinge.
Lightly tighten the two screws of the bottom hinge .
7. Confirm that the striker plate position is opposite a magnetic catch
when the door is closed and that no hinge screws are on the
mirror side of the door.
Door Adjustment
1. Check for clearance and alignment between mirror doors. It may be
necessary to adjust individual doors. Loosen the set screws on the
inside of the door hinges about a 1/4” turn for door(s) needing to be
adjusted. (FIG 9)
2. Realign so the doors are “square” and swing without interference.
3. Lightly retighten the set screws.
Back
View of
Door
“C “
(2 EA)
Back
View of
Door
“B”
(1 EA)
FIG 4
Striker
Plates
FIG 5
Pivot
Hinge
type
“c”
(3 EA)
Pivot
Hinge
type
“d”
(3 EA)
FIG 7
Pivot Hinge
type “c”
Pivot Hinge
type “d”
FIG 8
CAUTION: Do not over tighten the set screws. Screws
turned down too tight will break the mirror.
RECOMMENDED LAMPS:
60 watt maximum
Type G 25 or 40
Clear Incandescent
Medium Base (E27)
SERVICE PARTS
DESCRIPTION
PART NUMBER
OAK WHITE
Hinge Set ( 1 ea Top & Bottom) S7175 S7175
Magnetic Latch SB4247903 S7174
Socket Cup SB5629801 SB5629801
Mounting Screw 8 X 1-3/4” PPH Type A
Wall Anchors
Standard Hardware - may be purchased locally
Door
Back
Door
Back
Door
Front
FIG 9
Pivot Hinge
FIG 6
Hinge
Pressure
Pad
Backside of
Mirror Door