Installation Instructions

On each piece of plywood, measure and mark 9” from
the central part of the shortest edge of the board.
Measure and mark the center of the plywood.
STEP 1: MEASURe & mark Plywood
Using the 6” hole saw, cut out a hole centered on the
marked spot on both plywood boards. For best results, drill
on the lowest speed, take your time, and only apply light
pressure.
STEP 2: cut and sand the plywood
Using a random orbit sander, sand the plywood boards
until they’re smooth.
STEP 3: sand the plywood
Using a miter saw, cut the 2 x 4 lumber into four 48” long
pieces and four 24” long pieces for the frames.
STEP 4: Cut out the frame