Assembly Instructions

Measure nine 4" lengths on the 1/2" x 36" round dowel.
STEP 3: measure dowels
Cut out the nine 4" dowels.
STEP 4: cut dowels
Draw a line across the three marks made in the
previous step. Use a speed square to make sure the
line is perfectly straight.
STEP 6: cross marks
Mark each mark made in Step 5 by pressing down on each
location with the tip of the screwdriver.
STEP 7: mark drilling locations
Clamp all three boards together and set them upright. Mark
dowel locations on each board 2" from both ends and one
in the middle. You should end up with three marks on each
board, two at the ends and one directly center.
STEP 5: mark dowel locations