Installation Guide

Tips:
•
Both edges of the molding should be flush with the sides of your
miter box or saw. This is important for keeping the cuts consistent.
•
Not all walls will be structured at a perfect 90° angle. You can adjust
your miter angle on a miter saw if necessary.
•
Cuts are made with the profile upside down. As you cut, the ceiling
side (C) of the profile will be close to you and the wall side (W) will
be away from you.
Left Corner Piece: Miter right at 45°
Right Corner Piece: Miter left at 45°
Right Corner Piece: Miter right at 45°
SAVE
SAVE
SAVE
W
W
W
C
C
Outside 90° Corner
Instructions:
Inside 90° Corner
Instructions:
SAVE
C
Left Corner Piece: Miter left at 45°
W
Cutting your crown molding “In Position” refers to cutting it at the angle in which it will be installed. This is
recommended for first-timers and for those who will be using a miter box and hand saw.
How to Miter Nomastyl Crown Molding In
Position