Quick Guide

ManualsBrandsNomadix ManualsWearable TechnologySmart Badge

• Disconnecting the Smart Badge from the charging cable triggers an

automatic health check

• To initiate a manual health check, depress the alert button for 1 second

• Depress the alert button for 5 seconds

• The LED turns yellow, then red

• An alarm is triggered, you can release the button

• The Smart Badge must be worn vertically using a lanyard and be able to move freely

• In case of fall suspicion, the LED turns red

• The device then blinks while testing verticality and movement

•

• The Smart Badge sends Wi-Fi network analytics data (green blink) to the Cloud

Administration Console and synchronizes (orange blink) at regular intervals

• Connect the Micro USB cable to the device and to a power source

• When the Smart Badge indicates low battery (red LED), it must be charged for at least 4 hours before it can be used again

• Scans, alarms and synchronizations are deactivated during charging

• Set the Smart Badge to Learn Mode on the Cloud Administration Console

• Depress the alert button for 1 second. The LED turns orange, then white

• To trigger a manual beacon scan, depress the alert button for 3 seconds. The LED blinks white

• Once the LED returns to solid white, the Smart Badge is ready for another scan

• Connect the Micro USB cable to the device and to a power source

• Hold the alert button for 20 seconds until the LED blinks orange, and wait for the device to restart

•

using the

•

Nomadix Alerts | Smart Badge Quick Guide ALERTS-SB1

Version 1.1

INITIATE A HEALTH CHECK

TRIGGER AN ALARM

USE FALL DETECTION

WI-FI NETWORK ANALYTICS

RECHARGE A SMART BADGE

ENVIRONMENT LEARNING

RESET A SMART BADGE

FIRMWARE UPDATES

Alert Button

Charging LED

Status LED

SUCCESS

1 sec

5 sec

FAILURE

off

Battery low

Network error

Service error

Disabled

Please check the Smart Badge is operational before using it

Use of this Nomadix product constitutes acceptance of the Nomadix

EULA and product terms and conditions, which can be found here:

www.nomadix.com/eula

Summary of content (2 pages)

PAGE 1
Nomadix Alerts | Smart Badge Quick Guide ALERTS-SB1 Version 1.1 Please check the Smart Badge is operational before using it Alert Button Charging LED Status LED Use of this Nomadix product constitutes acceptance of the Nomadix EULA and product terms and conditions, which can be found here: www.nomadix.
PAGE 2
Appendix FCC Warnings This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.