User's Manual

Increased low end point value (more servo travel
on LOW end is possible).
Decreased low end point value (less servo travel
on LOW end is possible).
The position of the pointer on the bar is affected by end point settings (low and high) and trim setting;
increasing the low end point value may visually appear to have the same effect as decreasing the high
end point value.
An end point setting of 100 (the default) is typical for most servos, and should always be used for
ESCs. Larger setting values will overdrive most servos
Adjusting the Low End Point
The low end point value is a relative value, and is expressed as the percentage of full travel to the LOW
end.
Use the navigation controls to adjust the low end point as follows:
1. Access the top function menu from
the driving screen.
2. Navigate to the Channel 3 or
Channel 4 menu.
or then
3. Navigate to Low End Point.
or
Value Description
0 Minimum low end point; allows NO travel to low end.
1-199
Low end point value is set to a percentage of travel
range to low end.
4. Change the value.
or
200 Maximum low end point (will overdrive most servos)
Trim and EPA Interaction
A trim (or sub-trim) setting of 100 is equivalent to an End point setting of 50.