User's Manual

Firmware. If you have been instructed to update your transceiver(s) also, you will need to connect the
transceiver to the React using the Receiver Programming Cable inside the battery compartment. That
cable should plug into the “TACH” port on your transceiver. Once you are connected, select Install
Latest Transceiver Firmware.
Specifications
Specifications subject to change without notice.
React Controller
Radio Type: digital spread spectrum 2.4Ghz
Radio Mode: direct sequence (DSSS) and frequency
hopping (FHSS) spread spectrum
Range: 1000ft. (approximate)
Frame Rate: 100 frames per second
Latency: 10 millisecond max, 5ms typical
Dimensions: 300mm x 139mm x 125mm (HWD)
Weight (w/Batteries): 674g
Servo Channels: 4
Rechargeable Batteries: NiMH (included)
Controller Battery Voltage Monitor: graphic and real-
time
Car Battery Voltage Monitor: graphic and real-time
Timers: operation and lap timers
Trims: adjustable trims and sub-trims
Controls: dual rate, endpoints, exponential, mixing
and servo speed adjust on all channels
Anti-Lock: brake anti-lock with cycle, delay, and depth
Idle Up: yes
Tactile Alarm: programmable vibrator
Resolution: 128 x 64 pixels
Auto Modes: auto display and display only
Presets: failsafe and autostart
Telemetry: 3 channels of real time telemetry
Telemetry Sensors: speed, temperature and battery
Servos Supported: any combination of analog and
digital
PC Connectivity: USB serial for customization,
analysis and updates
Antenna: Internal
Architecture: software upgradeable
Transceiver
Dimensions: 47.7 x 30.2 x 19mm
Weight: 34g (including antenna)
Antenna length: 22.8cm
Antenna thickness: 1.8mm
Support
Nomadio is committed to providing the best support in the RC market for its products. If you have any
issues with your React, please visit our support website at
http://support.nomadio.net