User's Manual

1. Access the top function menu from the
driving screen.
2. Navigate to the Controller Setup menu.
or then
3. Navigate to and activate Calibrate.
or then
4. At the confirmation screen:
9. Select Yes to recalibrate
10. Select No to cancel the operation
or
5. Confirm your selection.
6. Perform the calibration routine by following the on-screen commands. Only move one control at a time, as directed by the
prompts, leave the other control centered in its hands-off position.
For best results, pull the trigger then gently release it before starting calibration. After calibrating the
brake travel, gently release the trigger. This will ensure that any mechanical dead zone in the trigger is
properly detected.
About
The About screen displays the version number and
ID number for your React.
If you are connected to a transceiver the version
number and VIN for the transceiver are also
shown.
This function also displays your startup screen and
user name. This is a great way to show off your
customized graphics to your friends!
Viewing the React About Screen
Use the navigation controls to view the about screen as follows:
1. Access the top function menu from the
driving screen.
2. Navigate to the Controller Setup menu.
or then
3. Navigate to and activate About.
or then
4. View the startup screen and user name, then
press OK.