User's Manual

Rebinding
You can rebind to the transceiver in a specific
model (identified by a model profile). An example
of when you might use this function would be if
you replaced a transceiver on your car – you need
to tell the React and the new transceiver to look
for each other.
Rebinding to a Model
Use the controls to rebind to a model as follows:
1. Access the top function menu from the
driving screen.
2. Navigate to the Manage Models menu.
or then
3. Navigate to Active Model.
or
4. Navigate to the model you want to
rebind with.
or
5. Navigate to and activate Rebind.
or then
6. If the receiver was previously bound to a different React, turn on the model and perform the binding process again by
activating the Bind button until the LED illuminates. Otherwise, just turn on the model.
Controller Setup
The following illustration shows the function menu structure for the controller setup functions: