User's Manual

1. Access the top function menu from the
driving screen.
2. Navigate to the Advanced menu.
or then
3. Navigate to the Failsafe menu.
or then
4. Navigate to Set Failsafes.
or
5. At the confirmation screen:
1. Select Yes to capture the servo
failsafe settings.
2. Select No to abandon the operation.
or
6. Confirm your selection.
7. A 3-second countdown begins on the display screen.
Before the countdown ends, use the React controls to set the servo failsafe positions. (For example, on a nitro car set steering
to centered and throttle to full brake.)
At the end of the countdown, a confirmation message indicates that the servo failsafe positions were stored.
8. To test the failsafe positions, turn off the React and observe the reactions of the connected servos. The servos should go to
the failsafe positions you just set.
You should always set your failsafe positions after making changes to your model, and should test your
settings before driving. An easy way to check the failsafe positions is to turn your model on before
turning on the React.
Speed
The Speed display uses the tach sensor and
several measurements you enter order to provide
you with accurate speed readout. This is where
you enter those measurements.
The React must be programmed with distance in
inches traveled per number of revolutions. The
sensor then “does the math” in real time to
provide you with a speedometer function that can
be used for alerts.
The two parameters that are used to make the
Speed calculations are rollout and revolutions.