User's Manual

Channel 3 / 4 Servo Speed
Input/Throttle Speed determines the percentage of
full speed that is applied to the throttle movements
that are above the throttle trigger setting. 100 is
maximum servo movement rate. 1 is minimum
rate. Default is 100 (full speed).
Return/Brake Speed determines the percentage of
full speed that is applied to braking movements
that are above the trigger setting. 100 is maximum
servo movement rate. 1 is minimum rate. Default
is 100 (full speed).
Trigger sets the minimum amount of control input
before the speed limiter becomes active. At 0%,
limiting is always active (input is always >= 0%).
At 50%, limiting is only active if the throttle is on
half way or more.
Brake Trigger sets the minimum amount of
control input before the speed limiter becomes
active. At 0%, limiting is always active (input is
always >= 0%). At 50%, limiting is only active if
the brake is on half way or more.
Shift Servo mode set for 4WS Shift Servo mode set for Thr/Brake
Input/Throttle Speed acts as Input Speed
Return/Brake Speed acts as Return Speed
Trigger acts as Trigger
Brake Trigger is not used
Input/Throttle Speed is Throttle Speed
Return/Brake Speed acts as Brake Speed
Trigger acts as Throttle Trigger
Brake Trigger acts as Brake Trigger
Changing the Channel 3 / 4 Servo Speed
Use the navigation controls to change the steering servo type as follows:
1. Access the top function menu
from the driving screen.
2. Navigate to the Channel 3 or
Channel 4 menu.
or then
3. Navigate to Throttle Speed.
or