User's Manual

90
Sending Settings to the Sensor
Sending Settings to the SensorSending Settings to the Sensor
Sending Settings to the Sensor
You can send your settings to the Sensor by choosing the Connection menu and then
choosing Send Settings to Sensor. You can also send your settings by choosing the Send
Settings to Sensor toolbar button. If you forget to send your settings to the Sensor after
editing them, the Digital RC Desktop will prompt you to send your settings on exit.
Installing Sensor Firmware
Installing Sensor FirmwareInstalling Sensor Firmware
Installing Sensor Firmware
To install new Sensor Firmware, choose the
Connection menu and then choose Install Latest
Sensor Firmware. If you have been instructed to
update your transceiver(s) also, you will need to
connect the transceiver to the Sensor using the
Receiver Programming Cable inside the battery
compartment. That cable should plug into the
“TACH” port on your transceiver. Once you are
connected, select Install Latest Transceiver Firmware.