User's Manual

60
Configuring Event Settings
Use the navigation controls to configure the Event Settings as follows:
Event Summary
For each Event, the “Affects” column shows which Vibration Patterns and Sounds in the RC
Desktop are tied to that event.
The units for Speed and Temperature are based on the Units setting in the Controller setup
menu.
Event Level Default Affects Description
TX Battery
(0.0– 10.0 volts) 4.1 volts Sound: Tx battery
Vibe: TxBat Vibe
Low Transmitter
battery voltage
warning
Car Battery
Car (0.0 – 20.0 volts)
RX (0.0 – 10.0 volts)
7.0 volts
4.1 volts
Sound: Car Battery
Vibe: CarBat Vibe
Low car battery
voltage warning
Temperature
(0-450 degrees) 270 degrees Sound: Temperature
Vibe: Temp Vibe
Over-temperature
warning. 4 Different
levels for the
different temp sensor
ports
Speed
(0-200) 55 Sound: Speed
Vibe: Temp Vibe
Speed threshold
notification
Connection
N/A Sound: Connected,
Disconnected
Notification when
connectin
g
to or
1. Access the top function menu from the driving
screen.
menu
2. Navigate to the Advanced menu.
or
: then
3. Navigate to the Events submenu.
or
: then
4. Navigate to the submenu for the Event which
you wish to configure (see table below)
or
: then
Value Description
Off
Does not alert user (ignores any sounds or
vibes selected in the RC Desktop)
Sound Plays only the sound selected in RC Desktop
for that event
Vibe
Vibrates, with pattern selected in RC
Desktop, when event occurs.
Both
Plays both sound and vibrates when event
occurs.
5. Change the Alert value.
or
6. Change the Level Value See Table Below