User's Manual

58
Changing the Channel 3 / 4 Servo Speed
Use the navigation controls to change the steering servo type as follows:
1. Access the top function menu
from the driving screen.
menu
2. Navigate to the Shift (Ch3) or
Channel 4 menu.
or : then
3. Navigate to Throttle Speed.
or
Value Description
Input/Throttle
Speed
The amount of limiting applied to servo
throttle motion once the trigger amount has
been exceeded.
4. Change the values.
or
Return/Brake
Speed
The amount of limiting applied to servo
brake motion once the trigger amount has
been exceeded.
Trigger
The percentage of full throttle range that will
be limited.
Brake Trigger
The percentage of full braking range that will
be limited.
Interaction with other Settings
• Servo Speed is applied after Expo. The trigger levels refer to the curved input value.
• ABS is applied after Brake Speed, so Brake Speed can limit how quickly the brake input
moves to the ABS Active region, but once there ABS pulses happen at full speed.
• Servo Speed is applied after AutoStart, so if the AutoStart Level is set higher than the
Throttle Speed Trigger, the servo movement will be slowed.
• Idle Up only takes effect when the trigger is centered. Throttle Speed can slow down
the return to center and therefore slow down Idle Up activation. Once Idle Up is
started, the servo will jump to the set position.