User's Manual

Changing the servo trim has the following visual effect on the driving screen bars:

Servo trim is centered in range (value = 0)

Servo trim is offset to high end (+ve value)

Servo trim is offset to low end (-ve value)

Adjusting Channel 3 / 4 Servo Trims

Use the navigation controls to adjust shift servo trim as follows:

1. Access the top function menu

from the driving screen.

2. Navigate to the Shift (Ch3) or

Channel 4 menu.

or : then

3. Navigate to Trim.

Value Description

0 Shift servo trim is centered within the

servo range.

-ve value

(-100 Æ -1)

Shift servo trim is to the LOW end.

4. Change the value.

+ve value

(1 Æ 100)

Shift servo trim is to the HIGH end.

Trim and EPA Interaction

A trim (or sub-trim) setting of 100 is equivalent to an End point setting of 25.

Channel 3 / 4 Servo Dual Rate

Channel 3 and Channel 4 servo

dual rates adjust the range of

servo movement when the grip

buttons are activated. The servo

dual rate value is applied to both

low and high ends, and is

expressed as a percentage of

servo range (configured by end

point adjustments).

Steering (Ch1)

Throttle (Ch2)

Shift (Ch3)

Ch4

Ch3 / Ch4 Dual Rate Ranges

On the driving screen, servo dual rate range is represented by the solid length

of the bottom bar. The total length of the bar (solid and dotted) represents

the servo range. The length of the solid bar represents the servo range as set

by the dual rate value.