User's Manual

Adjusting Throttle Dual Rate Increment

Use the navigation controls to adjust throttle dual rate increment as follows:

1. Access the top function menu

from the driving screen.

2. Navigate to the Throttle (Ch2)

or : then

3. Navigate to DR Increment.

Value Description

4. Change the value.

1-20

Throttle dual rate value changes by set

increment.

Use smaller values for finer dual rate

control.

Use larger values for coarser dual rate

control.

Brake End Point

The brake end point value

adjusts how far the

throttle goes to the BRAKE

end with respect to its full

range of motion to the

brake end. End point

adjustment should be

adjusted prior to other

throttle settings, as the

brake end point value

affects other throttle

settings.

The brake end point is set

independently of the

throttle end point (which

adjusts how far the

throttle moves to the

THROTTLE end).

The brake end point setting should be used to do the following:

• Limit throttle throw to reduce mechanical binding or servo strain that may occur on full

servo throw to the brake end. For example, if the servo is trying to pull a mechanical

brake linkage farther than it is mechanically able.

• Adjust braking range to reduce the full braking force of the vehicle.