User's Manual

52
The position of the pointer on the bar is affected by end point settings (low
and high) and trim setting; increasing the high end point value may visually
appear to have the same effect as decreasing the low end point value.
Adjusting the High End Point
The high end point value is a relative value, and is expressed as the percentage of full travel
to the HI GH end. For example, setting the high end point value to “50” allows the servo to
move only 50% of full travel to the high end.
Use the navigation controls to adjust the high end point as follows:
1. Access the top function menu
from the driving screen.
men
u
2. Navigate to the Shift ( Ch3)
menu.
or : then
3. Navigate to High End Point.
or
Value Description
0
Minimum high end point; allows NO travel to high
end.
1-99
High end point value is set to a percentage of
travel range to high end.
For example, a value of “50” gives 50% of full
travel to high end.
4. Change the value.
or
100
Maximum high end point; allows FULL travel to
high end.
Trim and EPA I nteraction
A trim (or sub-trim) setting of 100 is equivalent to an End Point setting of 20.