User's Manual

28
The position of the pointer on the bar is affected by the steering end point values (left
and right) and trim setting; increasing the right end point value may visually appear to
have the same effect as decreasing the left end point value.
Adjusting the Right End Point
The right end point value is a relative value, and is expressed as the percentage of full travel
to the right. For example, setting the right end point value to “50” allows the steering servo to
turn only 50% of full travel to the right.
Use the navigation controls to adjust the right end point as follows:
1. Access the top function menu
from the driving screen.
men
u
2. Navigate to the Steering (Ch1)
menu.
or : then
3. Navigate to Right End Point.
or
Value Description
0
Minimum right end point; allows NO turning
motion to the right.
1-99
Right end point setting is set to a percentage of
full right-turning range. For example, a value of
“50” gives 50% of full right-turning range.
4. Change the value.
or
100
Maximum right end point; allows FULL right-
turning range.
Trim and EPA I nteraction
A trim (or sub-trim) setting of 100 is equivalent to an End Point setting of 20.