User's Manual

Charging occurs as follows:

system turned off

When you connect the system to the battery charger, the blue LED begins to flash.

When the battery is fully charged, the blue LED stops flashing and stays on.

system turned on

When you connect the system to the battery charger, the red LED begins to flash.

When the battery is fully charged, the red LED turns off.

N.B.: If the device has not been charged for a long time (a few months), it may not be possible to turn on

the system during the first few minutes of the charging, as the voltage may drop below the minimum

limit.

14. LIMITED WARRANTY

With this LIMITED WARRANTY CERTIFICATE, Nolangroup warrants this Product to be free from defects in

material and workmanship at the time of its original purchase by the buyer.

We invite you to:

- Read the cautions pertaining to safety and proper use.

- Read the warranty terms and conditions.

- Keep the originals sales receipt. This must be shown in case of repairs covered by warranty. In these

cases, the product has to be taken back to the dealer where it was purchased.

14.1. Warranty coverage

If any defect covered by this limited warranty certificate is discovered within 2 (two) years from the

purchase date shown on the tax receipt, Nolangroup shall repair or replace the defective product

through its distribution network after having verified the defect. Nolangroup shall supply all the material

and labor that is reasonably required to remedy the defect, except in those cases where the damage is

caused by one of the items listed in the following paragraph “Exclusions and limitations of the

Coverage”.

14.2. Exclusions and limitations of the coverage

This warranty only covers defects in materials and manufacturing. Nolangroup shall not be considered

responsible for product defects that can be attributed, either partially or in full, to any other cause,

including but not limited to:

 Defects or damages resulting from using the Product in conditions that differ from the usual ones.

 Damages caused by improper use not conforming with normal operation in accordance with the

product operating and maintenance instructions provided by Nolangroup.

 Negligence and normal wear of internal and external parts.

 Any damage caused by an accident;

 Any change or modification made to the helmet or to the N-Com system by the user or by third

parties.

 Color changes or damages caused by exposure to harmful chemical products.

 The use of incompatible accessories that are not part of the N-Com product range.

 Moreover, the warranty does not cover product defects caused by fortuitous events, modifications

or adjustments, causes of force majeur or damages deriving from the product coming in contact

with liquids.

 The internal helmet components are not and cannot be waterproof. Consequently, any improper

exposure to rain, humidity, food spillages or other liquids can result in damages to the N-Com

electronic devices, damages for which Nolangroup shall not be responsible.