User's Manual

B5
7
3. INSTALLATION
Important: Prior to installing the N-Com system, it is recommended to write down the identification
code affixed to the product (see chapter 17.5).
You can download the installation video from www.n-com.it N-Com / Download section.
Before you install the B5 system on the helmet, make sure it turns on properly. Press the onkey
for about 2 seconds, until the LED lights up and you hear a beep in the headset. Proceed with the
installation.
Remove the cheek padding (see helmet instructions).
Fig. 1
Remove the helmet edge gasket using the
special tool (Fig. 1).
Remove the “N-Com” plugs found at the
back of the shell gasket and on the left side
of the helmet (Fig. 1).
Fig. 2
Completely remove the gasket as shown in
Fig. 2; by doing so you also remove the
padding.
Prior to installing the N-Com system, remove any filling foam material found in the helmet.
Option 1: remove the bottom element in foam material and the filling materials in the housings of the N-
Com earpieces located in the EPS cheek pads.
Option 2: remove the left and right side filling material as well as the filling material in the housings of the
N-Com earpieces located in the EPS cheek pads.