User's Manual

B5
17
13. “UNIVERSAL INTERCOM” INTERCOM
The N-Com B5 system can be connected via Bluetooth to intercom systems of other brands, thanks to
the UNIVERSAL INTERCOM function.
13.1. Pairing up the UNIVERSAL INTERCOM
The N-Com system can be paired up to an intercom of a different brand (from now on referred to as
Intercom B) as if it was a mobile phone.
1. Put the N-Com system in Setting Mode: press the “on” key and keep it pressed for 4 seconds,
until the blue LED starts to flash quickly;
2. Put intercom B in the mobile phone pairing up mode (refer to the Intercom B manual);
3. When both systems are in the pair up mode (setting), on the N-Com system press the
command related to the “setting position” where you wish to store intercom B (CHANNEL 1-
3), see paragraph 12.1;
4. After a few seconds, Intercom B will emit the “phone connection” confirmation beep;
5. To turn on communication between the two, briefly press the “on” key on the N-Com system.
13.2. Universal Intercom Function
To turn on and off the audio between two helmets, proceed as follows:
From the N-Com system:
Connect or disconnect Intercom B as you would for a regular N-Com intercom (chapter 11-12)
Interco B receives a dialing one that must be answered with a phone reply command.
From an intercom of a different brand
Press the “Voice Call” command. The N-Com system receives a dialing tone; answer by pressing any key.
To disconnect the intercom, press “Voice Call” once again.
N.B.:
 The N-systems keeps an active connection with a mobile phone or a GPS even during Bluetooth
communication with other intercom systems.
 The intercom system connected to N-Com may not allow simultaneous connection to a mobile
phone.