User's Manual

4. BASIC FUNCTIONS

System ON

Press “on” and keep it pressed for about 2 seconds, until the LEDs turn on

and you hear a beep in the headset.

System OFF

Press “on” and keep it pressed for about 6 seconds, until the LEDs turn off

and you hear a beep in the headset.

Increase Volume

Briefly press “” to increase the volume. A double tone signals the highest

volume level.

Decrease Volume

Briefly press “” to decrease the volume. A double tone signals the lowest

volume level.

4.1. N-Com Wizard and N-Com App

“N-Com Wizard” is the PC application that can be used to manage and configure the B5

system.

The programme can be downloaded from the Internet site www.n-com.it, in the

“Download” section. In order to use it, a helmet equipped with B5 must be connected to

the PC, using the USB cable supplied with the system.

The functions that can also be managed from the N-Com Wizard are listed here below with

the specific icon.

The N-Com system is preset to be hooked up to the “N-Com App”, the application compatible

with Android, iPhone and iPad that can be used to configure and operate the N-Com system

directly from a Smartphone.

With the N-Com App, you can carry out most of the functions included in the N-Com Wizard

program or, alternatively, it can be used as a wireless Bluetooth keypad.

The N-Com APP can be downloaded free of charge from Google Play or Apple Store.

For additional details, please visit the website www.n-com.it

The functions that can also be managed from the N-Com Wizard are listed here below with

the specific icon.

4.1. Pairing up with Bluetooth devices

 Put the system in setting mode: press the “on” key and keep it pressed for 4 seconds, until the

blue LED starts to flash quickly;

 Turn on the search for Bluetooth devices (smartphone, GPS, MP3 reader) on the device;

 Select the N-Com device. If a password is requested, enter 0000 (four zeros);

 Connection between the two devices is established after a few seconds.

Note: The affiliation is stored in the helmet and in the cell phone and it is not lost when the two devices

are turned off. As a result it needs to be carried out only once.

Automatic Connection

Once the Bluetooth device has been paired up, connection is automatic

when the system is turned on.

Manual Connection

In case connection is not automatically initiated after a few seconds, you

can connect from the Bluetooth device or by pressing “on” and “n” at the

same time.