User's Manual

10
3.1. Removing the B5 system from the helmet
Proceed as follows to remove the B5 system from the helmet:
 Remove the cheek padding and the shell gasket;
Fig. 7
 Remove the keypad from the shell, using a
flat head screwdriver (or a similar tool) to
lever upwards in the special hollow as
shown in fig. 7.
Fig. 8
 Unhook the right and left clips from
the shell, levering upward using a flat
head screw (or a similar tool), as
shown in figure 8.
Fig. 9
 Completely remove the B5 system from
helmet using a flat head screwdriver (or
similar tool) and re-install the cheek
padding and the edge gasket.