User's Manual

8
3. INSTALLATION
3.1. Preliminary operations – Jet helmets or Flip-up helmets
 Open the helmet chin guard (only on Flip-up helmets).
 Pull out both comfort cheek pads, left and right, from the helmet. (Fig. 1)
 Remove the noise reducers from the cheek pads (if present) and cut the insert using a
pair of scissors, following the pre-cut dots. Reposition the noise reducers in the
removable cheek pads.
 Take out the rear section of the comfort padding, pulling on the neck roll until it is
released from the shell. Reposition the padding on the outside of the helmet for the time
being.
 Unhook the press-stud of the polystyrene cheek pads by pulling toward the inside of the
helmet (Fig. 2), then remove the cheek pad by pulling it upward.
Warning: in case the polystyrene cheek pad is damaged during this operation, please
contact your local dealer to replace it.
 Cut out the round foam insert that covers the speaker housing from the polystyrene
cheek pad using a pair of scissors, following the pre-cut dots. (Fig. 3).
3.2. Preliminary operations – Full-face helmets
 Remove both comfort cheek pads, left and right, from the helmet (see specific
instructions in the helmet user manual). (Fig. 4)
Fig. 1 Fig. 2
Fig. 3
Fig. 4 Fig. 5 Fig. 6a
Fig. 6b
Fig. 7