User's Manual

12
3.6. Posizionamento dell’e-box
 Connect the microphone to the e-box
 Position the e-box in the left polystyrene cheek pad housing
 Posizionare l’altoparlante sinistro nella sede del guanciale e fissarlo utilizzando
l’apposito adesivo (Fig. xx)
Nota: PRIMA di riposizionare il guanciale polistirolo sinistro, seguire le istruzioni del
capitolo successivo.
3.7. Installing the adhesive keyboard
 Remove the N-Com plug from the left side of the helmet; to make this easier, it is
recommended to push the plug from the inside of the helmet. (Fig. 11)
 Thoroughly clean the outside surface of the shell to make sure that the adhesive
keyboard sticks properly. Before you apply the keyboard, make sure that the shell area
is completely clean and grease or dirt free.
 Posizionamento dell’antenna
 far uscire l’antenna dalla tastiera
 posizionare l’antenna nella tastiera
 Remove the protective film from the back of the adhesive keyboard using the special
tab. (Fig. 12)
 Pass the Flex cable of the keyboard through the hole in the outer shell. (Fig. 13)
 Apply the keyboard to the shell and press down on its entire surface to make sure that
it sticks properly.
Fig. 11 Fig. 12 Fig. 13
Fig. 11 Fig. 12 Fig. 13
Fig. 14
Only for Jet helmets or flip-up helmets:
Carry out the operation with the chin guard
open, as shown in figure 14.