User's Manual

16
Note: If a Bluetooth device (mobile phone or GPS) equipped with music player with
Bluetooth A2DP player has already been paired up, the pairing up DOES NOT have to
be repeated as the A2DP protocol has already been stored in the B1 .
Once the Bluetooth device has been paired up, connection is automatic when the system is
turned on.
6.1. Affiliation reset function
You can remove all affiliated devices from the system memory. This operation is not
reversible; right after resetting, you will have to repeat the affiliation procedure for the cell
phone (or for other compatible Bluetooth devices).
To erase all devices previously affiliated, proceed as follows:
Press on and keep it pressed (for more than 4 seconds), until the LEDs start to flash
quickly and you hear a sharp beep in the headset, indicating the Pair-up mode ;
Press and at the same time for 4 seconds, and release them when you hear a
beep . The N-Com will emit a special acoustic signal to confirm and will then turn itself
off.
This function can also be turned on through PC using the N-Com Wizard
programme.
7. MOBILE PHONE FUNCTIO NS
Answering a phone
call
Briefly press any key when you hear the incoming call signa l
Hanging
up/rejecting a
phone call
Press on and keep it pressed for about 2 seconds (until you
hear the acoustic signal)
Voice call (if
equipped)
Press on and keep it pressed for about 2 seconds (until you
hear the acoustic signal)
Redial last nu mber Briefly press and at the same time
Transferring a call
from helmet to
mobile phone
To transfer an ongoing call from the helmet to the mobile phone,
press both and at the same time and keep them
pressed for 4 seconds
Conference call function
B1 allows a conference call with Rider and Pillion Passenger .
When a call comes in on a mobile phone connected via Bluetooth to B1 , the Rider - Pillion
Passenger intercom is temporarily turned off. However, if you wish to share the phone call
with the other helmet, simply turn on the intercom manually during the phone call (by
briefly pressing on ).
Caution : this function is available only if the Pillion Passenger helmet is also equipped with
a N - Com system provided with the same function.
8. GPS SATELLITE NAVIGATOR FUNCTIONS
B1 is compatible with the most common satell ite navigators for motorcycles.
By connecting the N-Com system to the GPS, all instructions will be transferred to the
helmet.
Every time the navigator communicates instructions, the intercom via Bluetooth with the
Pillion Passenger is cut off and automatically restored at the end of the communication.