User's Manual

B4
45
Once the Bluetooth device has been paired up, connection is automatic when the
system is turned on.
If the connection is not established in automatic after some seconds, it is possible to
connect the device by pressing the “on” button for 4 seconds.
6.1. Affiliation reset function
You can remove all affiliated devices from the system memory. This operation is not
reversible; right after resetting, you will have to repeat the affiliation procedure for
the cell phone (or for other compatible Bluetooth devices).
To erase all devices previously affiliated, proceed as follows:
• Press “on” and keep it pressed (for more than 4 seconds), until the LEDs start to
flash quickly and you hear a sharp beep in the headset, indicating the “Pair-up
mode”;
• Press “▲” and “▼” at the same time for 4 seconds, and release them when you
hear a beep. The N-Com will emit a special acoustic signal to confirm and will then
turn itself off.
This function can also be turned on through PC using the “N-Com Wizard”
programme.
7. MOBILE PHONE FUNCTIONS
Answering a phone
call
Briefly press any key when you hear the incoming call signal
Hanging
up/rejecting a
phone call
Press “on” and keep it pressed for about 2 seconds (until you
hear the acoustic signal)
Voice call (if
equipped)
Press “on” and keep it pressed for about 4 seconds (until you
hear the acoustic signal)