User's Manual

Once it is turned on, cable connection stays active even in the subsequent menus.

Consequently, you can hear the device connected via cable even while listening to

music via A2DP or via RADIO.

The Bluetooth Kit3 can be connected with cables of the N-Com range of both the

Mono type (Multimedia Wire or Mobile Wire) and Stereo type (Multimedia Wire2).

Bluetooth Kit3 is pre-set to receive Stereo cables.

In order to use a Mono cable, a pre-selection needs to be carried out.

While in the pairing up mode (LEDs flashing quickly),

briefly press “” for 2 seconds (acoustic signal).

Mono cable pre-selection

This function can also be turned on through

PC using the “N-Com Wizard” programme.

11. INTERCOM MODE BETWEEN TWO HELMETS

In order to use Bluetooth Kit3 in wireless intercom mode, both helmets have to be

equipped with a Bluetooth kit.

There are two different intercom modes, depending on how the kit is used: Rider-

Pillion Passenger or Bike-to-Bike.

In order for two Bluetooth Kits to communicate with one another, they have to be

paired up first.

11.1. Intercom affiliation

1. Make sure both Bluetooth Kits are turned off;

2. Set both Bluetooth Kits in Pairing up mode by pressing “on” (for more than 4

seconds), until the LEDS start to flash quickly;

3. 3a. Rider-Pillion Passenger pair up

: On one of the two helmets, briefly press

“on”;