User's Instructions

9
Fig. 20 Fig. 21
 Hook up the microphone to
the connector coming out of
the e-Box (Fig. 20).
 Position the wiring and the
connectors behind the cheek
pad lining, lifting it with the
help of a flat head tool (Fig.
21).
Fig. 22
Fig. 23
 Pass the USB mini wire
through the elastic band
found on the comfort padding
(Fig. 22).
 Position the wiring and the
antenna in the rear part of the
helmet (Fig. 23).
Fig. 24 A – X-1005 HELMET
Fig. 24 B – X-903 HELMET
 On the right side of the
helmet, bend the cheek pad
lining and insert the battery in
its housing (Fig. 24 A/B - 25).
ONLY FOR X-1005 HELMETS:
Remove the filling material.
Keep it in case you want to
use the helmet without the N-
Com system installed in the
future.
Fig. 25 Fig. 26
 Position the right loudspeaker
in its housing, inserting the
cable in the special groove
(Fig. 26). If necessary, secure
the earphone using the
adhesive supplied as standard
equipment.
 Position the wiring and the connectors behind the cheek pad lining, lifting it up with the help of a
flat head tool.
3.4. Repositioning the padding
Reposition the internal comfort padding by following the specific instructions provided in the helmet
user manual.
Warning: Always verify the proper length of your chinstrap and adjust it if necessary, referring to the
specific helmet instructions.