User's Instructions

25
2. Any system can press the “n” key for 2 seconds to activate the Group Conference or to start
a conference communication between all the systems.
3. In the case where one of the systems presses the “n” key or falls outside the connection
range, the group intercom is interrupted.
Smart Conference connection
Press the “
n
” key for 2 seconds. Activation is confirmed by a
beep in the helmet and by the voice message “ Group Intercom” .
Smart Conference disconnection
Briefly press the “
n
” key. Disconnection is confirmed by the voice
announcement “ Group Intercom terminated ”.
N.B.: During a “ Smart Conference ” call, connection to the mobile phones of all participants is
temporarily cut off. When the conference call ends, all phones automatically reconnect to their own
intercom system.
N.B.: The “ Smart Conference ” mode can be used EXCLUSIVELY with “900” series N-Com systems”.
N.B.: The “ Smart Conference ” mode CANNOT be used with systems paired up in Universal Intercom
mode (chapter 18).
18. “UNIVERSAL INTERCOM” INTERCOM
The N-Com B902 system can be connected via Bluetooth to intercom systems of other brands, thanks
to the UNIVERSAL INTERCOM function
3
.
18.1. Pairing up the UNIVERSAL INTERCOM
The N-Com system can be paired up to the other intercom (from now on referred to as Intercom B)
as if it was a mobile phone.
 Make sure the B902 is turned off.
 Put the B902 system in the “Pairing up” menu: press the “ON” key and keep it pressed for 4
seconds, until you hear the voice announcement “ Pairing up Menu ”.
 Press the “” key until you reach the option “ Universal intercom pairing ”.
 Put intercom B in the mobile phone pairing up mode (refer to the Intercom B manual).
 After a few seconds, Intercom B will emit the confirmation beep.
N.B.: The system paired up using the UNIVERSAL INTERCOM is saved in the first available channel.
3
Except for Bluetooth kit and Bluetooth kit2, which are not compatible.