User's Manual

FCC, IC Warning statement

Certification and Safety Approvals

FCC Compliance Statement

This device complies with part 15 of the FCC rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC

rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will

not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment on and off, the user is encouraged to try to correct the interference by one or

more of the following measures:

• Reorient or relocate the receiving antennae

• Increase the separation between the equipment and the receiver

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

FCC RF Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow

the specific operating instructions for satisfying RF exposure compliance. The antenna used for this transmitter must not

transmit simultaneously with any other antenna or transmitter, except in accordance with FCC multi-transmitter product

procedures.

We, Nolangroup S.p.A. confirm that when equipped, the distance between antenna and one’s head is 34.5 mm. So,

We, Nolangroup S.p.A. confirm that when equipped, the helmet needs to be at least 34.5 mm apart from one's head.

Antenna Location

FCC Caution

Any changes or modifications to the equipment not expressly approved by the party responsible for compliance could void

user’s authority to operate the equipment.