User's Manual

14. N-COM INTERCOM

The N-Com B601 system allows communication with other N-Com systems, up to a maximum

distance of about 250 m (in open field, with no obstacles). The range of the communication varies

depending on the N-Com systems used.

Important: The procedure described below refers exclusively to the pairing up and operation between the

B601 and the

“900” / “600” series N-Com systems.

To pair up to N-Com systems of a range other than the

“900” / “600” series, please refer to the procedure

described in chapter 15

“Universal Intercom”.

N.B.: The range and quality of the communication may vary significantly depending on the presence

of obstacles, weather conditions, magnetic fields.

14.1. N-Com “900” ! “600” Series Intercom pairing up

　 Make sure the systems are turned off.

　 Put the systems in “Configuration” mode: press the “n” key and keep it pressed for 4 seconds,

until you hear the voice announcement

“Configuration”.

　 On both systems, press the key “　” until you reach the option “Intercom pairing”.

　 On system A, press the key pertaining to the “pre-setting position” where you wish to save

system B.

Pairing up CHANNEL 1 Briefly press “n”.

Pairing up CHANNEL 2 Press the “n” key twice.

Pairing up CHANNEL 3 Press the “n” key three times.

The Intercom connection with the selected channel is automatically activated at the end of the pair up

procedure.

14.2. N-Com “900” ! “600” Series Intercom function (one-to-one connection)

To establish an Intercom connection with one of the systems stored in memory, simply press the

command related to the channel where the system was saved.

Connection CHANNEL 1 Briefly press “n”.

Call CHANNEL 2 Press the “n” key twice.

Call CHANNEL 3 Press the “n” key three times.

Disconnection of active intercom Briefly press “n”.

N.B.: In case the pre-setting position is empty, or the system being called cannot be reached within

the maximum range or it is already engaged in a phone call, you will hear an error voice message.

N.B.: In case the Intercom connection system falls outside the range (Intercom connection

interrupted), the B601 system will automatically try to reconnect every 8 seconds. Double beeps will

be emitted until the Intercom connection is not restored.

If you do not want automatic reconnection, press the

“n” key to stop the automatic reconnection

attempts.