User's Manual

6. BASIC FUNCTIONS

Note: Before using the N-Com device for the first time, recharge the battery completely for at least 10

hours. To obtain best performances from the battery, it is recommended to completely recharge the

battery the first few times. Afterwards, you can recharge the battery for shorter periods. Whenever

possible, it is best to recharge the battery completely.

System ON

Press

“n” and keep it pressed for about 2 seconds, until the LEDs turn on

and you hear the voice announce ment.

System OFF

Press

“n” and keep it pressed for about 6 seconds, until the LEDs turn

off and you hear the voice announcement.

6.1. Volume adjustment

You can easily adjust the volume by tapping the

“　” button or the “　” button. You will hear a beep

when the volume reaches the maximum or minimum level.

The volume is independent for each sound source. Once it is set for a specific source (phone call, radio,

Mp3), it will be remain in memory even after the system is switched off.

However, if you adjust the volume during stand-by mode, it will affect volume levels of every audio

source.

6.2. N-Com EASYSET

“N-Com EASYSET” is the application that can be used to manage and configure the B601

system. The programme can be downloaded from the Internet site www.n-com.it, in the

“Download” section. The functions that can also be managed from the N-Com EASYSET

are listed here below with the specific icon.