User's Manual

4.4. Repositioning the padding
Pass the USB mini wire through the elastic band found on the comfort padding.
Replace the internal comfort padding by following the specific instructions found in the helmet user
manual.
Warning: Always verify the proper length of your chinstrap and adjust it if necessary, referring to the
specific helmet instructions.
Warning: After the B601 is installed on the helmet, make sure the microphone is properly positioned in
front of your mouth, if necessary adjusting the moveable element.
Warning: The wind protector, supplied as standard equipment with helmets that can be opened, may make
it more difficult to open and close the chin guard when the microphone is installed.
5. REMOVING THE SYSTEM
To remove the system from the helmet, proceed as for the installation, by removing the various parts.
Important: to remove the keypad support, proceed as follows.
Remove the keypad support from the helmet shell (Fig. 46).
Remove the Flex of the keypad from the connector found on the e-box (Fig. 47).
Now completely remove the keypad support from the helmet.
Fig. 46 Fig. 47
The keypad support can be removed in case you decide to no longer use the system. However, it cannot
be reused again as it will have lost its adhesive properties. Contact your local dealer to purchase a new
keypad support that will stick properly to the helmet shell.
15