User's Manual

Fig. 38 Fig. 39 Fig. 40

　 On certain helmets, the housing for the microphone rod must be

created by cutting out the helmet border gasket along the pre-

cut area (Fig. 41).

Fig. 41

FULL-FACE HELMETS

　 Take the polystyrene check pad (left side) and position the microphone in the special housing, as

illustrated in Fig. 42, being careful that the side of the microphone support with the letter

“n” is

facing towards the inside of the helmet (Fig. 43).

　 Secure the microphone to the cheek pad using the “microphone securing stickers”, see Fig. 42.

　 Connect the microphone to the connector coming out of the e-Box (Fig. 44).

　 Position the left-hand side speaker in the cheek pad housing and secure it using the specific

adhesive (Fig. 45).

　 Reposition the left polystyrene cheek pad in its housing.

ONLY FOR FULL-FACE HELMETS

: Insert the chin strap into the polystyrene cheek pad loop.

Fig. 42 Fig. 43

Fig. 44 Fig. 45