User's Manual

　 Remove the small N-Com cap positioned on the left side of the helmet. To make the operation

easier, we recommend pushing the cap from inside the helmet (Fig. 30).

　 Thoroughly clean the outside surface of the shell to make sure that the adhesive keyboard sticks

properly. Before you apply the keyboard, make sure that the shell area is completely clean and

grease or dirt free.

　 Remove the protective film from the back of the adhesive keyboard using the special tab (Fig. 31).

　 Pass the keypad flex through the hole in the outer shell (Fig. 32).

. 27

Fig. 28 Fig. 29

ONLY FOR X-702 HELMET:

Position the battery connector and wiring underneath the

shell gasket (Fig. 27).

　 Cut along the pre-cut lines of the plastic tab on the back of

the comfort padding (Fig. 28).

　 Secure the wiring underneath the plastic tab. Close the cut

parts using the cable fixing adhesives (Fig. 29).

Fig. 30 Fig. 31 Fig. 3

　 Apply the keyboard to the shell and press down on its entire

surface to make sure that it sticks properly (Fig. 33).

Fig. 33

Note: Make sure you do not glue the keypad flex underneath the keypad support.