User's Manual

4. INSTALLATION ON THE X-LITE HELMETS

This procedure must be followed for the installation of N-Com systems on X-lite helmets other than

model X-903.

Important: Prior to installing the N-Com system, it is recommended to write down the identification

code affixed to the product (see chapter 18.5).

The installation video can be seen at

www.n-com.it / Support section.

4.1. Preliminary operations

　 Remove the internal comfort padding by following the specific instructions provided in the helmet user

manual.

　 If present, remove from the polystyrene cheek pads the foam filling material that cover the

housings of the N-Com earphones. Keep this filling materials should you decide in the future to

use the helmet without the N-Com system installed.

4.2. Installing the system in the helmet

　 Connect the battery to the wiring system (Fig. 23).

　 Position the battery in the right polystyrene cheek pad housing and secure it using the Velcro

ribbon (Fig. 24).

　 Position the right-hand side speaker in the specific cheek pad housing and secure it using the

specific adhesive (Fig. 25).

　 Reposition the right polystyrene cheek pad in its housing.

ONLY FOR FULL-FACE HELMETS

: Insert the chin strap into the polystyrene cheek pad loop.

Fig. 23 Fig. 24 Fig. 25

　 Arrange the battery connector behind the polystyrene cheek

pad.

　 Arrange the cable behind the polystyrene shell or inside the

relevant housing (Fig. 26).

Fig. 26