User's Manual

3.2. Installing the system

The M1 system must be positioned in the back of the helmet, using the adhesive feet supplied as

standard equipment.

 Thoroughly clean the surface of the helmet where the feet will be applied;

 Make sure the safety block is properly listed, as shown in Fig. 3. If the safety block is closed, lift it as

explained in the chapter entitled “Removal”;

 Insert the fixing feet in the device (Fig. 4);

 Make sure the system is properly positioned on the helmet shell.

Fig. 3

Fig. 4

If necessary, depending on the different types of helmets, replace one or more thin feet with thicker

ones, until you find the combination that allows the e-box to properly stick to the helmet (Fig. 5-8).

Fig. 5

Fig. 6

Fig. 7

Fig. 8

Important: Should you wish to use the emergency brake light (see Chapter 12), you need to position

the M1 system so that it is vertical or with an inclination of +/-30° with respect to the vertical axis

while you are riding, so as to allow the triaxial accelerometer to properly measure the motorcycle

deceleration. Based on the type of helmet used and the riding style, choose the combination of

feet (thick-thin) that allows proper positioning.