User's Manual

FOR USA AND CANADA MARKET ONLY: SPECIAL WARNING

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device

may not cause harmful interference, and (2) this device must accept any interference received,, including interference that

may cause undesired operation of the device.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority

to operate the equipment.

NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this

equipment. Such modifications could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the

FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and receiver.

 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

 Consult the dealer or an experienced radio/TV technician for help.

This model meets the government’s requirements for exposure to radio waves. Your wireless device is a radio transmitter

and receiver. It is designed and manufactured not to exceed limits for exposure to radio frequency (RF) energy set by the

Federal Communications Commission (FCC) of the U.S. Government and by the Canadian regulatory authorities.

RF Radiation Exposure Statement - The device has been evaluated to meet FCC and RSS-102 general RF exposure

requirement. The device can be used in portable exposure condition without restriction.

For Canada market only: This device complies with Industry Canada license‐exempt RSS standard(s). Operation is subject

to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any

interference, including interference that may cause undesired operation of the device.

Model: M1.5 FCC ID: Y6MNCOM14 IC: 9455A-NCOM14

R-NZ

Bluetooth is a registered trademark property of Bluetooth SIG, Inc.

FOR USA AND CANADA MARKET ONLY: LIMITED WARRANTY

Limited warranty certificate valid for 2 (two) years from the date of purchase.

Dear Customer,

Thank you for choosing a Nolangroup N-Com device.

PLEASE READ CAREFULLY ALL THE CLAUSES AND CONDITIONS OF THIS LIMITED WARRANTY CERTIFICATE.

By this LIMITED WARRANTY CERTIFICATE, Nolangroup guarantee to the original purchaser of the N-Com that the product

is free from all material and manufacturing defects at the time of purchase.

COVER PROVIDED BY THE WARRANTY

If any defect covered by this limited warranty certificate comes to light within 2 (two) years from the date of purchase,

Nolangroup shall proceed, through their distribution networks and after verifying the defect, to repair or replace the

defective product. Nolangroup shall supply all the materials and provide all the labor reasonably necessary to remedy the

reported defect, except for cases in which the damage is attributable to one of the reasons listed in the paragraph below,

entitled “Exclusions and limitations of cover”.