User's Manual

M1
17
11. RIDER-PASSENGER INTERCOM MODE
In order to use M1 in wireless intercom mode, both helmets have to be equipped with a N-Com
Bluetooth system.
In order for two N-Com systems to communicate with one another, they have to be paired up first.
11.1. Intercom affiliation
1. Make sure both N-Com Bluetooth systems are turned off;
2. Set both N-Com Bluetooth systems in Pairing up mode by pressing “on” (for more than 4
seconds), until the keypad LEDS start to flash quickly;
3. On either one of the two helmets, press “on” briefly;
4. After a few seconds, the helmets “recognize” each another, a beep is emitted to signal the pair up
was successful and intercom communication is activated;
5. Turn off both N-Com Bluetooth systems and turn them back on to store the pair up data.
11.2. Intercom function
To activate the intercom connection, turn on the two N-Com systems and briefly press “on” on one of
the helmets.
Intercom activation With M1 turned on, briefly press “on”.
Intercom deactivation With M1 turned on, briefly press “on”.