User's Manual

6. PAIRING UP BLUETOOTH DEVICES

In order for the M1 system to be connected to another Bluetooth device, the latter needs to be first

paired up with the N-Com system.

The pairing up procedure is the same for all Bluetooth devices: mobile phones, MP3 Bluetooth

players, satellite navigators, etc.

1. Make sure the M1 is turned off;

2. Press “on” and keep it pressed (for more than 4 seconds), until the keypad LEDs start to

flash quickly and you hear a sharp beep in the headset, indicating the “Pair-up mode”;

3. On the Bluetooth device, turn on the search for Bluetooth devices (refer to the instructions

manual of your device for the proper pairing up procedure, as it varies depending on the

brand and model of the device);

4. After a few seconds, the device will display the name “N-Com M1 v.X.XX”, followed by the

manufacturer’s identification data;

5. Select the N-Com device. If a password is requested, enter 0000 (four zeros);

6. M1 will confirm the pairing up by means of a tone in the headset, and the keypad LEDs will

stop flashing;

7. Turn off and on both the device and the M1 to store the pairing up data.

Note: The affiliation is stored in the helmet and in the cell phone and it is not lost when the two

devices are turned off. As a result it needs to be carried out only once.

Note: If a Bluetooth device (mobile phone or GPS) equipped with music player with Bluetooth A2DP

player has already been paired up, the pairing up DOES NOT have to be repeated as the A2DP

protocol has already been stored in the M1.

Once the Bluetooth device has been paired up, connection is automatic when the system is turned

on.

6.1. Affiliation reset function

You can remove all affiliated devices from the system memory. This operation is not reversible; right

after resetting, you will have to repeat the affiliation procedure for the cell phone (or for other

compatible Bluetooth devices).

To erase all devices previously affiliated, proceed as follows:

 Press “on” and keep it pressed (for more than 4 seconds), until the keypad LEDs start to flash

quickly and you hear a sharp beep in the headset, indicating the “Pair-up mode”;

 Press “+” and “-” at the same time for 4 seconds, and release them when you hear a beep. The N-

Com will emit a special acoustic signal to confirm and will then turn itself off.

This function can also be turned on through PC using the “N-Com Wizard” programme.