User's Manual

M1
11
3.3. Installing the adhesive keypad
Thoroughly clean the helmet surface to which the keypad will be applied;
For better grip to the helmet, if necessary, apply the “M1 wiring bi-adhesive” supplied as standard
equipment to the back of the keypad flex cable. Fig. 14
Remove the protective film on the keypad and apply it to the helmet.
Remove the protective film of the “M1 wiring bi-adhesive” and make it stick to the shell.
Fig. 14
Fig. 15
Important: If the position is less than perfect, remove the foot from the helmet immediately and try
again.
NB: It will take up to 24 hours for the adhesive to stick completely. During this time, do not expose
the helmet to atmospheric agents.
Caution: Once the adhesive is applied, it cannot be reused in a different position and will have to be
replaced once removed.
3.4. Positioning the speakers
Remove the protective film from the Velcro of
the speakers;
Position the speakers near your ears, so that
they stick perfectly to the helmet.
N.B.: If possible, position the speakers
underneath the comfort padding of the
helmet.
Fig. 1
6