User's Manual

Important: When positioning the e-box on the helmet, the wiring connector must not stick out from

the edge of the helmet or be twisted (fig. 9 and 10).

Fig.

Fig. 1

 Remove the protective film from the feet and apply the system to the helmet (Fig. 11-13);

 Close the safety block by pressing it downward, as shown in Fig. 12;

Important: If the position is less than perfect, remove the foot from the helmet immediately and try

again. See the following chapter for instructions on how to remove the system.

Fig. 11

Fig. 12

Fig. 13

NB: It will take up to 24 hours for the adhesive to stick completely. During this time, do not expose

the helmet to atmospheric agents. During the first 12 hours, do not remove the system from the

feet.

Caution: Once the adhesive is applied, it cannot be reused in a different position and will have to be

replaced once removed.