User's Manual

B1.4
13
6. MOBILE PHONE FUNCTIONS
Answering a phone call Briefly press any key when you hear the incoming call signal
Hanging up/rejecting a
phone call
Press “
on
” and keep it pressed for about 2 seconds (until you hear the
acoustic signal)
Voice call (if equipped)
Press “
on
” and keep it pressed for about
2
seconds (until you hear the
acoustic signal)
Redial last number Briefly press “” and “” at the same time
Transferring a call from
helmet to mobile phone
To transfer a
n ongoing call from the helmet to the mobile phone, press
both “” and “” at the same time and keep them pressed for 4 seconds
Conference call function
B1.4 allows a conference call with Rider and Pillion Passenger.
When a call comes in on a mobile phone connected via Bluetooth to B1.4, the Rider-Pillion Passenger
intercom is temporarily turned off. However, if you wish to share the phone call with the other helmet,
simply turn on the intercom manually during the phone call (by briefly pressing “on”).
Caution: this function is available only if the Pillion Passenger helmet is also equipped with a N-Com
system provided with the same function.
7. GPS SATELLITE NAVIGATOR FUNCTIONS
B1.4 is compatible with the most common satellite navigators for motorcycles.
By connecting the N-Com system to the GPS, all instructions will be transferred to the helmet.
Every time the navigator communicates instructions, the intercom via Bluetooth with the Pillion
Passenger is cut off and automatically restored at the end of the communication.
Note: If the navigator is pre-set for connection to a Bluetooth mobile phone, you will be able to receive
the phone call audio directly in the helmet through the GPS. In this case, you can answer the call
directly from the navigator.
GPS Conference Call Function
The Conference function allows you to keep the “Rider-Pillion Passenger” intercom open even while the
satellite navigator is giving instructions, thus preventing the intercom mode to be turned off every time
the navigator gives instructions. However, if you wish to activate the Conference GPS function, simply
turn on the intercom manually during the GPS directions (by briefly pressing “on”).
Caution: this function is available only if the Pillion Passenger helmet is also equipped with a N-Com
system provided with the same function.
At the end of the GPS communication, the intercom with the second helmet stays open and the
"Conference" setting is stored for future GPS communications.