Manualshelf

User's Manual

ManualsBrandsNolangroup ManualsElectronicsBluetooth low energy remote control
12345678910
M5
7
Once you find the correct position of the e-box, keep it in position with a certain pressure in
order to assure the correct adhesion of the adhesive.
N.B.: It will take up to 24 hours for the adhesive to stick completely. During this time, do not expose the
helmet to atmospheric agents. Do not apply pressure on the e-box and do not remove it from the
feet.
Caution: Once the adhesive is applied, it cannot be reused in a different position and will have to be
replaced once removed.
2.3. Positioning the wireless keypad
The wireles keepad can be placed where you like, within a range of 5 meters from the e-box. Generally
the best position is on the left side of the helmet
Thoroughly clean the outer surface of the shell to ensure that the keypad sticks properly.
Decide the best position for the keypad, verify that the base of the keypad has a perfect
contact with the choosen surface
Remove the protective film and apply the keypad to the helmet, making sure the entire
surface of the adhesive sticks perfectly to the shell.
N.B.: In case the adhesive plate is not in the right position, peel it off immediately from the
helmet and repeat the positioning.
Once you find the correct position of the keypad, keep it in position with a certain pressure in
order to assure the correct adhesion of the adhesive.
N.B.: It will take up to 24 hours for the adhesive to stick completely. During this time, do not expose the
helmet to atmospheric agents. Do not apply pressure on the keypad and do not remove it.
Caution: Once the adhesive is applied, it cannot be reused in a different position and will have to be
replaced once removed.
3. BASIC FUNCTIONS
System ON
Press “BACK” and keep it pressed for about 2 seconds, until the LEDs turn
on and you hear a beep in the headset.
System OFF
Press “BACK” and keep it pressed for about 2 seconds, until the LEDs turn
on and you hear a beep in the headset.
Increase Volume
Briefly press “” to increase the volume. A double tone signals the highest
volume level.
Decrease Volume
Briefly press “” to decrease the volume. A double tone signals the lowest
volume level.
3.1. N-Com Wizard
“N-Com Wizard” is the PC application that can be used to manage and configure the M5
system.
The programme can be downloaded from the Internet site www.n-com.it, in the “Download” section. In
order to use it, a helmet equipped with M5 must be connected to the PC, using the USB cable supplied
with the system.