User's Manual

3. INSTALLATION

Important: Prior to installing the N-Com system, it is recommended to write down the identification

code affixed to the product (see chapter XX).

3.1. Preliminary operations – Jet helmets or Flip-up helmets

You can download the installation video from www.n-com.it X-Series Download section.

 Open the helmet chin guard (only on Flip-up helmets).

 Pull out both comfort cheek pads, left and right, from the helmet. (Fig. 1)

 Remove the noise reducers from the cheek pads (if present) and cut the insert using a pair of scissors,

following the pre-cut dots. Reposition the noise reducers in the removable cheek pads.

 Take out the rear section of the comfort padding, pulling on the neck roll until it is released from the

shell. Reposition the padding on the outside of the helmet for the time being.

 Unhook the press-stud of the polystyrene cheek pads by pulling toward the inside of the helmet (Fig.

2), then remove the cheek pad by pulling it upward.

Warning: in case the polystyrene cheek pad is damaged during this operation, please contact your local

dealer to replace it.

 Cut out the round foam insert that covers the speaker housing from the polystyrene cheek pad using a

pair of scissors, following the pre-cut dots. (Fig. 3).

3.2. Preliminary operations – Full-face helmets

Fig. 1

Fig. 2

Fig. 3

Fig. 4

Fig. 5

Fig. 6a