User's Manual

20
13. BIKE TO BIKE INTERCOM
The N-Com system is used for bike-to-bike communication up to a distance of about 800 m (open
terrain, no obstacles).
The M5 system entails the use of a default “STANDARD” commands configuration, or the use of a
“FRIENDS” configuration that can be turned on from the N-Com Wizard or dedicated App.
The difference between the two configurations lies in the number of motorcycles that can be hooked up:
the STANDARD configurations allows up to 3 different motorcycles to be hooked up to the M5 system,
while the FRIENDS configurations allows up to a total of 6.
Important: If you use the FRIENDS configuration, you need to visit the N-Com website and download the
dedicated commands diagram (section Download/Command Summary Diagram).
N.B.: The range and quality of the communication may vary significantly depending on the presence of
obstacles, weather conditions, magnetic fields.
N.B.: The range of the communication varies depending on the N-Com systems used.
13.1. Bike-to-Bike Intercom Affiliation (Standard configuration)
 Put both systems A and B in Setting Mode (press the “on” key and keep it pressed for 4
seconds, until the red LED starts to flash quickly);
 On system A, press the command related to the “setting position” where you wish to store
system B;
Pairing up CHANNEL 1 Briefly press “n”.
Pairing up CHANNEL 2 Press the “n” key twice.
Pairing up CHANNEL 3 Press the “n” key three times.
Pairing up CHANNEL 4 Briefly press “on”.
Pairing up CHANNEL 5 Press the “on” key twice.
Pairing up CHANNEL Press the “on” key three times.
N.B.: Channels 4-5-6 can be used with the FRIENDS configuration only.
CHANNEL 1 is typically used for the Rider-Pillion Passenger connection, however it can also be used for
the Bike-to-Bike intercom.
The use of CHANNEL 1 is different from the other channels due to the following specific characteristics:
 When the systems are turned on, the intercom is automatically activated.
 The Phone Conference function and the GPS Conference function can be used.
13.2. Bike to bike intercom function
How the Bike-to-Bike call works (Standard Configuration)
Connection CHANNEL 1 Briefly press “n”.
Call CHANNEL 2 Press the “n” key twice.
Call CHANNEL 3 Press the “n” key three times.
Disconnection of active intercom Briefly press “n”.