User's Guide

4
Copyright Nolan Systems Inc. 2005
[e-mail]
http://www.nolan-sys.com/
This material may not in whole or part be copied, or communicated to third parties without Nolan Systems prior agreement in
writing.
Nolan Systems – USA
1595 Cleo Springs Dr.
San Jose, Ca. 95131, USA
Tel: [phone] Fax: [phone]
Insert AAA battery
The headset is powered with a cell of AAA battery. Please insert an AAA battery before use.
The talk time is dependent with the capacity of battery.
Insert AAA Battery
1. Open the battery chamber cover (refer to Fig 1).
2. Insert an AAA battery as shown on the label at the entrance to the battery chamber,
making sure the positive (“+”) and negative (“-”) terminals are in the correct orientation.
3. Close the battery chamber cover.
Turn on / off the Headset
To turn on the headset
Press and hold the Talk button for four seconds. You will hear an ON tone and the
LED will flash. The headset turns on and is placed in standby mode, ready to make
and receive calls.
To turn off the headset
Press and hold the Talk button for four seconds. You will hear an OFF tone or the
LED will light off. The headset is turned off. Then release the Talk button.
Pair the Headset with Bluetooth enabled devices
Pairing is the process of linking the headset with your Bluetooth mobile phone.
Before you use the headset with your mobile phone, you must pair both devices. After
pairing is completed, you can use the headset only with the paired mobile phone. If
you wish to use the headset with a different mobile phone, you must redo the pairing
process with the new mobile phone. In this case, the headset will no longer work with
the previous mobile phone.
Before you commence pairing the headset, ensure that the battery is fully charged.
To pair the device
1. With the headset turned off, press and hold the TALK button for 5 seconds.
You will hear a PAIRING tone, and the LED will flash at 1 second interval.
2. Release the TALK button. The headset is now in Pairing Mode.
3. Turn on the mobile phone and place it within 10 feet of the headset.
4. Initiate the device discovery feature on the mobile phone. Refer to the mobile
phone user guide for instructions for initiating this feature.
5. When prompted by the mobile phone, enter the headset pin code “0000”.
When pairing is completed, the LED on headset will flash at three seconds
interval and the headset will be placed in standby mode, ready to make and
receive calls.
To cancel pairing mode
While you are in pairing mode, you can cancel the pairing process and turn off the
headset.