User's Manual

The PulseDive has an internal 1650mAh Lithium Polymer battery. Charge the

PulseDive before initial use. Charging will take approximately 2 hours.

Charging

You can charge the device with a USB charger, a powerbank, on a PC or in your

car using the included charging cable.

* The charging time may be longer for USB chargers rated less than 1 Amp or older

type of PCs.

While charging, the red LED will light up solid. When the battery is full, the green

and red LEDs will light up together. If there is any problem during charging, the

green LED will start blinking.

Battery Indicators

At start up:

Red and green LEDs blink once: Battery is full

Green LED blinks once: Battery is half full

Red LED blinks once: Battery is empty

When the batteries are completely depleted, the red and green LEDs light up every

5 seconds. For a short period of time, the device will continue to work and then it

will emit a single beep and shut down.

Battery Warnings

IMPORTANT! The device does not work while charging.

Do not expose the device to extreme temperatures (for example a car's trunk or

glove compartment)

Do not charge the battery in temperatures over 35° C (95° F) or below 0° C (32° F).

The PulseDive battery can only be replaced by Nokta Makro Detectors or its

authorized service centers.

BATTERY INFORMATION