User Guide

For your safety
Read these simple guidelines. Not following them may be
dangerous or against local laws and regulations. For
further information, read the complete user guide.
Keys and parts
1 Call key
2 Left selection key
3 Scroll key
4 Earpiece
5 Flashlight
6 Right selection key
7 Power/End key
8 Back cover opening slot
9 Headset connector
10 USB connector
To lock the keys, select Go to > Lock keypad.
To unlock the keys, press briefly, and select Unlock.
Do not connect to products that create an output signal,
as this may damage the device. Do not connect any
voltage source to the audio connector. If you connect an
external device or headset, other than those approved
for use with this device, to the audio connector, pay
special attention to volume levels.
Parts of the device are magnetic. Metallic materials may
be attracted to the device. Do not place credit cards or
other magnetic stripe cards near the device for extended
periods of time, since the cards may be damaged.
Some of the accessories mentioned in this user guide,
such as charger, headset, or data cable, may be sold
separately.
Note: You can set the phone to ask for a security
code. The pre-set code is 12345. Change it to protect
your privacy and personal data. Note, however, that when
you change the code, you need to remember the new
code, as HMD Global is not able to open or bypass it.
This phone cannot be located or locked remotely if lost.
Insert the SIM card
Use only original mini-SIM cards. Use of incompatible SIM
cards may damage the card or the device, and may
corrupt data stored on the card.
Note: Switch the device off and disconnect the
charger and any other device before removing any
covers. Avoid touching electronic components while
changing any covers. Always store and use the device with
any covers attached.
1. Put your fingernail in the small slot at the bottom of
the phone, lift and remove the cover.
2. If the battery is in the phone, to remove it, lift it out.
3. Slide the SIM card in the SIM card slot.
4. If you have a dual-SIM phone, slide the second SIM in
the SIM2 slot. Both SIM cards are available at the same
time when the device is not being used, but while one
SIM card is active, for example, making a call, the other
may be unavailable.
Tip: To find out if your phone can use 2 SIM cards, see the
label on the sales box. If there are 2 IMEI codes on the
label, you have a dual-SIM phone.
5.Put back the battery.
6.Put back the cover.
SWITCH OFF IN RESTRICTED AREAS
Switch the device off when mobile phone use is not allowed
or when it may cause interference or danger, for example, in
aircraft, in hospitals or near medical equipment, fuel,
chemicals, or blasting areas. Obey all instructions in
restricted areas.
ROAD SAFETY COMES FIRST
Obey all local laws. Always keep your hands free to operate
the vehicle when driving. Your first consideration while
driving should be road safety.
INTERFERENCE
All wireless devices may be susceptible to interference,
which could affect performance.
AUTHORIZED SERVICE
Only authorized personnel may install or repair this product.
BATTERIES, CHARGERS AND OTHER ACCESSORIES
Use only batteries, chargers, and other accessories
approved by HMD Global for use with this device. Do not
connect incompatible products.
KEEP YOUR DEVICE DRY
Your device is not water-resistant. Keep it dry.
PROTECT YOUR HEARING
To prevent possible hearing damage, do not listen at high
volume levels for long periods. Exercise caution when
holding your device near your ear while the loudspeaker is in
use.
SAR
This device meets RF exposure guidelines when used either
in the normal use position against the ear or when
positioned at least 5 mm (0.2 inches) away from the body.
The specific maximum SAR values can be found in the
Certification Information (SAR) section of this user guide.
For more info, go to www.sar-tick.com.
When a carry case, belt clip or other form of device holder is
used for body-worn operation, it should not contain metal
and should provide at least the above-stated separation
distance from the body. Note that mobile devices may be
transmitting even if you are not making a voice call.
5
10
4
2
3
6
1
7
9
8
Switch your phone on or off
Press and hold the power key.
Charge the battery
1.Plug the charger into the wall outlet.
2.Connect the charger to the phone. When done, unplug
the charger from the phone then from the wall outlet.
If the battery is completely discharged, it may take
several minutes before the charging indicator is
displayed.
Make a call
1.Type in the phone number.
To type in the + character used for international calls,
press * twice.
2.Press . If asked, select which SIM to use.
3.To end the call, press .
Answer a call
Press .
Send messages
1.Select Menu > Messages > Create message.
2.Write your message.
3.Select Opt. > Send.
4.Type in a phone number, or select Search and a
recipient from your contacts list.
5.Select OK. If asked, select which SIM to use.
You can send text messages that are longer than the
character limit for a single message. Longer messages
are sent as two or more messages. Your service provider
may charge accordingly. Characters with accents, other
marks, or some language options, take more space, and
limit the number of characters that can be sent in a single
message.
Listen to radio
Select Menu > FM radio. When the phone asks if you want
to search all available channels, select OK.
• To switch between stations, scroll up or down.
• To save a found channel, select Opt. > Save channel.
• To change the volume, scroll left or right.
• To turn off the radio, select Stop.
Find your model number and serial
number (IMEI)
If you need to contact your care point or your service
provider, you may need info such as the model number
and the serial number (IMEI). To see the model number,
dial *#0000#. To see the serial number, dial *#06#.
If you have a dual SIM phone, only IMEI1 is needed. You
can also find the info on your phone label, which is located
under the battery.
The IMEI is also visible on the original sales box.
Product and safety info
For info on HMD Global Privacy Policy, go to www.nokia.com/phones/
privacy. For the online user guide, even more info, and
troubleshooting help, go to www.nokia.com/mobile-support.
Note: Pre-installed system software and apps use a significant
part of memory space.
Network services and costs
You can use your device on the GSM 850, 900, 1800, 1900 networks.
You need a subscription with a service provider.
Using some features and services, or downloading content, including
free items, require a network connection. This may cause the
transfer of large amounts of data, which may result in data costs. You
may also need to subscribe to some features.
Emergency calls
Important: Connections in all conditions cannot be guaranteed.
Never rely solely on any wireless phone for essential communications
like medical emergencies.
Before making the call:
• Switch the phone on
• If the phone keys are locked, unlock them.
• Move to a place with adequate signal strength.
1. Press the end key repeatedly, until the home screen is shown.
2. Type in the official emergency number for your present location.
Emergency call numbers vary by location.
3. Press the call key.
4. Give the necessary info as accurately as possible. Do not end the
call until given permission to do so.
You may also need to do the following:
• Put a SIM card in the phone.
• If your phone asks for a PIN code, type in the official emergency
number for your present location, and press the call key.
• Switch the call restrictions off in your phone, such as call barring,
fixed dialling, or closed user group.
Take care of your device
Handle your device, battery, charger and accessories with care.
The following suggestions help you keep your device operational.
• Keep the device dry. Precipitation, humidity, and all types of
liquids or moisture can contain minerals that corrode electronic
circuits. If your device gets wet, remove the battery, and let the
device dry.
• Do not use or store the device in dusty or dirty areas.
• Do not store the device in high temperatures. High temperatures
may damage the device or battery.
• Do not store the device in cold temperatures. When the device
warms to its normal temperature, moisture can form inside the
device and damage it.
• Do not open the device other than as instructed in the user guide.
• Unauthorized modifications may damage the device and violate
regulations governing radio devices.
• Do not drop, knock, or shake the device or the battery. Rough
handling can break it.
• Only use a soft, clean, dry cloth to clean the surface of the device.
• Do not paint the device. Paint can prevent proper operation.
• For optimal performance, switch the device off and remove the
battery from time to time.
• Keep the device away from magnets or magnetic fields.
• To keep your important data safe, store it in at least two separate
places, such as your device, memory card, or computer, or write
down important info.
Restore original settings
To reset your phone to its original settings and to remove all your
data, on the home screen, type in *#7370#.
Recycle
When this device has reached the end of its working life, all of its
materials can be recovered as materials and energy. Recycle
packaging and user guides at your local recycling scheme. When you
cooperate and deliver all these materials to one of the available
collection sites, you contribute in helping the environment and help
to ensure the health of future generations.
All electrical and electronic products and batteries may contain
recyclable metals and other potentially hazardous substances and
must be taken to their respective collection sites at the end of their
working life. Under no circumstances should you break open a
battery or other related materials. Do not dispose of these products
as unsorted municipal waste, as this may cause contamination of the
environment or risks to human health. All HMD Global products are in
compliance with the applicable industry international production
standards and to all requirements defined by the competent
government agencies.
Crossed-out wheelie-bin symbol
The crossed-out wheelie-bin symbol on your product, battery,
literature, or packaging reminds you that all electrical and electronic
products and batteries must be taken to separate collection at the
end of their working life. Do not dispose of these products as
unsorted municipal waste: take them for recycling. For info on your
nearest recycling point, check with your local waste authority.
Battery and charger info
Use your device only with an original BL-L5G rechargeable battery.
Charge your device with the AC-18 charger. Charger plug type may
vary. HMD Global may make additional battery or charger models
available for this device.
Electrical Information of the Charger
The following electrical information corresponds to the above-
mentioned charger models:
Input: 100-240 Vca; 50-60Hz; 0,1A
Output: 5Vcc; 0,55A
Charger safety instructions
The charger is suitable to be used only with compatible devices.
The charger should not be used in extremely high or low
temperatures.
Ventilation should not be obstructed by covering the charger with
magazines, blankets, curtains etc.
Open flames, such as candles, should not be placed above the
charger.
The charger and the wall outlet shall be easily accessible at all times.
In case the cable or the plugs are damaged, stop using them.
The charger requires very low maintenance. If you want to clean it,
use a dry cloth or a brush.
Meaning of the symbols:
For internal use only
The charger should not be disposed as unsorted municipal
waste. It should be recycled.
Battery and charger safety
Once charging of your device is complete, unplug the charger from
the device and electrical outlet. Please note that continuous charging
should not exceed 12 hours. If left unused, a fully charged battery will
lose its charge over time
Always keep the battery between 15°C and 25°C (59°F and 77°F) for
optimal performance. Extreme temperatures reduce the capacity
and lifetime of the battery. A device with a hot or cold battery may
not work temporarily.
Obey local regulations. Recycle when possible. Do not dispose as
household waste.
Do not expose the battery to extremely low air pressure or leave it to
extremely high temperature, for example dispose it in a fire, as that
may cause the battery to explode or leak flammable liquid or gas.
Do not dismantle, cut, crush, bend, puncture, or otherwise damage
the battery in any way. If a battery leaks, do not let liquid touch skin
or eyes. If this happens, immediately flush the affected areas with
water, or seek medical help. Do not modify, attempt to insert foreign
objects into the battery, or immerse or expose it to water or other
liquids. Batteries may explode if damaged.
Use the battery and charger for their intended purposes only.
Improper use, or use of unapproved or incompatible batteries or
chargers may present a risk of fire, explosion, or other hazard, and
may invalidate any approval or warranty. If you believe the battery or
charger is damaged, take it to a service center or your phone dealer
before continuing to use it. Never use a damaged battery or charger.
Only use the charger indoors. Do not charge your device during a
lightning storm.
To unplug a charger or an accessory, hold and pull the plug, not the
cord.
Additionally, the following applies if your device has a removable
battery:
• Always switch the device off and unplug the charger before
removing the battery.
• Accidental short-circuiting can happen when a metallic object
touches the metal strips on the battery. This may damage the
battery or the other object.
Small children
Your device and its accessories are not toys. They may contain small
parts. Keep them out of the reach of small children.
Medical devices
Operation of radio transmitting equipment, including wireless
phones, may interfere with inadequately shielded medical devices'
function. Consult a physician or the medical device's manufacturer to
determine if it is adequately shielded from external radio energy.
Implanted medical devices
To avoid potential interference, manufacturers of implanted medical
devices (such as cardiac pacemakers, insulin pumps, and
neurostimulators) recommend a minimum separation of 15.3
centimeters (6 inches) between a wireless device and the medical
device. Persons who have such devices should:
• Always keep the wireless device more than 15.3 centimeters (6
inches) from the medical device.
• Not carry the wireless device in a breast pocket.
• Hold the wireless device to the ear opposite the medical device.
• Switch the wireless device off if there is any reason to suspect
that interference is taking place.
• Follow the manufacturer directions for the implanted medical
device.
If you have any questions about using your wireless device with an
implanted medical device, consult your health care provider.
Hearing
Warning: When you use the headset, your ability to hear outside
sounds may be affected. Do not use the headset where it can
endanger your safety.
Some wireless devices may interfere with some hearing aids.
Nickel
The surface of this device is nickel-free.
TA-1465/TA-1453
EN-LATAM
Quick guide Nokia XX
SP70Z03Z1760Y V1.0
xxxxxxxxxx
EN_LATAM_SP70Z03Z1760Y_No
kia_XX_QG_issue_1.fm Page 1